St. Petersburg, FL

-Dig trench 40 ft from new garage to existing mainline at house -4 inch schedule 40 pvc - install two cleanouts -demo concrete around existing location in order to install flange for toilet - connect to the water lines at heater - run hot and cold lines 40 feet to garage from house - Uponor pipe used for installation -install three angle stops -install toilet -install p trap for sink - install faucet for sink

Dig down 3 to 4 feet with an excavator. Locate sewer lateral on corner of home. Reroute sewer line under trailer to new location outside of house footprint. Reconnecting to sewer pipe after infusion approximately 12 to 16 feet in main. Schedule 40 PVC pipe. Install two-way cleanout. Fill hole and trench back in.

Patch leak in wall by cutting out a piece of 1in cpvc and putting back together

**THE AMOUNT REFLECTED ON THIS INVOICE IS THE FINAL 60% OF THIS PROJECT KITCHEN -CONNECT EXISTING ICE MAKER TO THE NEW SUB ZERO REFRIDGERATOR (THIS MIGHT HAVE TO BE LOWERED BECAUSE THE CURRENT LOCATION MIGHT BE TO HIGH AND THE THAT WILL PREVENT THE NEWM SUB ZERO FROM BEING PUSHED BACK COMPLETLEY -KITCHEN FAUCET APEX WILL REMOVE AND REPLACE APEX WILL REPLACE ANGLE STOPS WITH NEW QUARTER TURN ANGLE STOPS AND REPLACE SUPPLY LINES WITH BRAIDED STAINLESS STEEL. APEX WILL INSTALL NEW DISPOSAL AND DISHWASHER. APEX WILL DISCONNECT GAS AND CONNECT GAS FOR THE NEW RANGE MASTER BATHROOM -INSTALL NEW STANDARD TOILET CONNECT WATER WITH HARD PIPED CHROME SUPPLY LINE, INSTALL TWO STANDARD WIDE SPREAD FAUCET STAINLESS STEEL SUPPLY LINES AND REMOVE AND REPLACE EXISTING SHOWER TRIM LAUNDRY -DEMO LAUNDRY SINK WATER AND SEWER, RELOCATE THE CURRENT LAUNDRY BOX TO NEW LOCATION WITH-IN 5 FT. 3RD FLOOR LAUNDRY BATHROOM DEMO THE WATER AND THE SEWER 2 LAVS, TOILET AND SHOWER, INSTALL PLUMBING FOR 1 SINK AND 1

Found fill valve hose dry-rotted and disconnected in men’s bathroom toilet. Found hand sink behind einstein bros counter leaking from top of p-trap and missing a gasket Estimate: - Will replace rubber hose from fill valve to slush valve - Will install tubular extension with new gasket for hand sink Found 3 compartment sink faucet in back dripping constantly. Found hand sink by coffee island dripping constantly Estimate: - Will remove and dispose of old cartridges - Will install new T&S Eterna cartridges in each faucet - Includes 2 hot side, 2 cold side, and one LTC cartridge

- Client states that the current tenant is not getting long lasting hot water. They want to replace the old 30 gallon hot water tank with a new 38 gallon hot water tank the tank is elevated roughly 10 feet in the air. - We have to drain the old Tank - Shut off power to the Tank - Cut the hot and cold copper lines - Remove the tank from its elevated spot - Dispose of the old Tank - Purchase and deliver new tank - Elevate the Tank 10 feet to the top of the old bathroom - Hook up the old hot and cold water lines to the new copper to the new Tank - Hook up the electric - Fill the tank test the fixtures This job comes with a six year parts and labor warranty

Found Moen 1/2 HP garbage disposal jammed up. Reset disposal and unjammed. Pulled out string and rubber. It is now working properly.

Estimate: - Will remove and replace seats and stems from 3 handle shower valve - Will install new chrome trim and caulk edges

Leak detection test Create ground access so that we can determine exactly the scope of work involved in repairing water leak under asphalt. Will have to break up asphalt along with dirt removal to determine where leak is coming from. Once pinpointed will create new estimate for repairing the leak. Did leak detection. Found leak location. Cut open asphalt and gained ground access. Dig out a 2’ x 2’ section and dig up a shovel and a half trench and leak was coming from further below. Will come back to find exact location tomorrow.

Sent over estimates to replace their hose bibs. Nancy said that once the doctor sees the estimate they will look it over since they were busy. They may also want to have other work done as well. I told them I’d reach out to them in a day or so to see what the final decision will be.

Found pinhole leak on 3/4” copper close to old gate valve. There are two valves on line. One is new ball valve. Estimate Recommended: - Will cut out old gate valve close to pinhole - Will repipe in copper and delete gate valve

8 FOOT SPOT REPAIR WHERE THE ROOTS HAVE COMPREMISED THE PIPE WE CAMERA ALL THE MAIN LINES IN THE BUILDING. THE MAIN LINES RUN DOWN THE CENTER OF EACH BUILDING. THE BUILDING THAT RUNS EAST TO WEST WHILE FACING THE BUILDING HAS 140 FEET THAT RUNS EAST TO WEST AND TYE INTO THE MAIN LINE AT THE END OF THE BUILDING. THE BUILDING THAT RUNS NORTH TO SOUTH IS A SEPERATE MAIN LINE THAT RUNS DIRECTLY DOWN THE CENTER OF THAT BUILDING IT LEAVES THE STRUCTURE APPROX HALF WAY UP THE BUILDING AND THAT WHERE THE CLEAN-OUT IS BY THE POOL AREA. THE PIPE THAT RUNS UP AND DOWN THE MAIN LINE IS 185 FT AND THEN 120 FEET TO THE MAIN LINE. THE TOTAL FOOTAGE OF THE MAIN LINE THAT HAS TO BE REHABBED WITH EPOXY IS 445. 10 YEAR WARRANTY ON OUR REPAIRS AND THE EPOXY PIPE WE WILL HAVE TO INSTALL MORE ACCESS TO THE PIPE (CLEAN-OUTS) BECAUSE SOME OF THE RUNS ARE TO LONG I PUT PRICES FOR 4 CLEANOUT ON THE ESTIMATE BE AWARE IF WE HAVE TO ADD MORE BECAUSE WE CANNOT OPEN THOSE CLEAN-OUT INSIDE I WILL HAVE TO CHARG

Cut/break concrete around toilet flange cut out old flange and piece of riser. Replace part of riser and install new flange

Replace current tankless that is producing 6.6 gpm to something bigger.

Remove old 40 gal electric heater from closet Cut out copper from existing copper for removal Install new 40 gal electric State commercial grade heater Connect water heater to existing copper using pex uponor once connected we will test to ensure there are no leaks and is functioning properly 4 year parts and labor warranty Replace illegal p trap under sink with new p trap up to code After install we will test to ensure waste arm is functioning properly

Chip and remove concrete on the back side of kitchen to allow access to the existing waste arm and Vent stack. Once we get concrete removed we will remove old copper was arm all the way back to existing vent stack in the wall. We will install new sch 40pvc for the waste arm. We will carry it from the kitchen p trap all the way to the vent stack in the wall Apex isn’t responsible for concrete put back or any dry wall or cabinetry that may need to be replaced

Remove cracked o ring gasket from wing L Replace gasket inside plastic purge cap

From the existing water meter in the side of home we will run new copper on the side of home with a new Prv and hose bib. We will jump the copper line out into the attic. Once we get into the attic we will transfer from copper to Uponor pex. We will run new pex throughout the attic and disperse to all the fixtures in the home kitchen, laundry, water heater, toilet, shower, and vanity in both bathrooms. We will install a new hose bib on the back side of home near pool area. We will cut access in dry wall on the back side of wall for for the guest bathroom laundry and kitchen. We will also have to cut access in the ceiling to get access to the master bathroom ceiling. Once we get to the bathrooms and laundry we will disperse the uponor pex to each fixture and stub out copper for stiff connections on the new angle stop install. For the island kitchen we will chip and remove concrete under the stove as well as under the dishwasher, we will then undermine the rest of the rest of the way to

Remove angle stop Install new angle stop Remove angle stop Install new angle stop Remove angle stops Install new anglestops

Estimate Recommended: - Will pick up toilet from supply house - Will drain and remove old toilet from second story hallway bathroom - Will install new American Standard toilet with new wax ring and bolts - Will haul away old toilet

Estimate Recommended: - Will run camera through shower drain to see if there is a p-trap or not

Cable through vent stack

Found dishwasher drain draining into open 2” p-trap. Water overflowing when kitchen sink is ran. Snaked through kitchen vent stack and cleared blockage. It is no longer overflowing. Gave estimate for hydroscrub and dishwasher drain extension to kitchen sink. Estimate Recommended: - Will snake kitchen vent stack and clear blockage - Will snake through tub overflow

Upon arriving at location customer cancelled at door saying that she already hired someone who was there at the time I arrived.

- Client is having constant clogging in his sewer system. The client is looking for a solution to make the sewer system run efficient again. - The Hydroscrub machine consists of high pressure water to blast out any old sewage or debris that has a crude overtime in the sewer system. - We have to locate the main line where it pops out of a house in the front yard. We will do that via the camera after I drop the clog. - We will dig down to the main line, cut out, roughly a 5 foot piece of cast-iron sewer. - We will dig roughly 3 foot down so we could wash all the debris and old sewage out into the hole. - We pull toilet or enter the sewer system via the vent stacks. Whatever works more efficiently to get this job accomplished. - We used a pacote machine to chain knock the 4 inch sewer. This machine has a 4 inch diameter chain links with carbide blades in which heat all the corrosion off the four-inch pipe that has accrued overtime in the sewer system. - We will chain knock both ba